MenuClose
Features of ZSC Series High Density Cleaner
Good Technological Parameter. The input pulp concentration of high density cleaner is generally set as 2%-5%. As we all know, the lower concentration of input pulp is, the heavy impurities easier to reach the inner wall of the cone through the pulp layer, the better effectiveness of deslagging. Therefore, the input pulp concentration of our company’s high density cleaner is generally controlled between 0.15MPa-0.35MPa. The general range of input pulp pressure is 0.2-0.5mpa. If the pulp enters the next equipment directly, the input pulp pressure can be controlled at 0.4-0.5mpa.
Wear-resistant Ceramic Cone, long service life. As the content of impurities in modern waste paper is increasing, manual sorting consumes a lot of manpower and material resources. As a result, many paper factory directly break down the slurry, which causes a large amount of heavy impurities into the pulp after breaking. These heavy impurities wear heavily on the cone of the high density cleaner, and the ordinary stainless steel cone only lasts for a few months. The high density cleaner produced by our company adopts wear-resistant ceramic cone tube, which has a service life of 3-5 years or even longer. This allows the user to no longer replace the cone tube often, which reducing the maintenance burden.
In conclusion, a good high density cleaner can make a large profit with a small investment and it can effectively protect the following equipment while obtaining high quality pulp. Welcome to contact us by email if you have interest in our products:
Email: leizhanpapermachine@gmail.com